HIKVISION AXHub User Manual

Note
Only -P model supports this funcon.
Prompt Fault When Arming
If the device applies EN standard, by default, the funcon is
disabled. In this case, the device will not prompt faults during
the arming procedure.
Note
Only -P model supports this funcon.
Enable Early Alarm
If you enable the
funcon, when the zone is armed and the
zone is triggered, the alarm will be triggered aer the delay
me.
Note
The early alarm will be taken eect only aer the delayed zone
is triggered.
Delay
When the early alarm funcon is enabled, you should set the
delay me. The alarm will be triggered aer the congured
delay me.
Fault Check
The system determines whether to check the faults listed on the
page. The system will only check the fault that is selected.
Detect Network Camera Disconnecon
If the opon is enabled, when the linked network camera is
disconnected, an alarm will be triggered.
Baery Supervision
If the opon is enabled, when baery is disconnected or out of
charge, the device will not upload events.
Wired Network Fault Check
If the
opon is enabled, when the wired network is
disconnected or with other faults, the alarm will be triggered.
Wi-Fi Fault Check
If the opon is enabled, when the Wi-Fi is disconnected or with
other faults, the alarm will be triggered.
Cellular Network Fault Check
If the
opon is enabled, when the cellular data network is
disconnected or with other faults, the alarm will be triggered.
SIM Card Fault Check
If the opon is enabled, the alarm will be triggered for faults of
the SIM card.
Telephone Line Cut
O Detecon
If the opon is enabled, the alarm will be triggered when the
phone line connected to the PSTN module disconnects.
RS-485 Excepon Detecon
If the opon is enabled, the alarm will be triggered when the
RS-485 bus of device has
excepon.
39

HIKVISION AXHub Specifications

General

Brand	HIKVISION
Model	AXHub
Category	Control Panel
Language	English