HIKVISION DS-2TD6237-50H4L/W - Set same Unit; Security; Authentication

Note
You should keep the parameters of the device and the computer or terminal all the same.
3. Click Save.
13.13 Set Same Unit
Set the same temperature unit and distance unit. When you enable this funcon, the unit cannot
be congured separately in other seng pages
Steps
1. Go to
Conguraon → System → System Sengs → Unit Sengs .
2. Check Use Same Unit.
3. Set the temperature unit and distance unit.
4. Click Save.
13.14 Security
You can improve system security by seng security parameters.
13.14.1
Authencaon
You can improve network access security by seng RTSP and WEB authencaon.
Go to Conguraon → System → Security → Authencaon to choose authencaon protocol
and method according to your needs.
RTSP
Authencaon
Digest and digest/basic are supported, which means authencaon informaon is needed when
RTSP request is sent to the device. If you select digest/basic, it means the device supports
digest or basic
authencaon. If you select digest, the device only supports digest
authencaon.
WEB Authencaon
Digest and digest/basic are supported, which means authencaon informaon is needed when
WEB request is sent to the device. If you select digest/basic, it means the device supports digest
or basic authencaon. If you select digest, the device only supports digest authencaon.
Note
Refer to the specic content of protocol to view authencaon requirements.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
89