HIKVISION DS-2TD6237-50H4L/W - Lens Parameters Adjustment; Conduct 3 D Positioning

2. Set PTZ, display
sengs, OSD, video/audio and VCA resource parameters.
-
For PTZ sengs, see Lens Parameters Adjustment .
-
For display sengs, see Display Sengs .
-
For OSD sengs, see OSD .
-
For audio and video sengs, see Video and Audio .
-
For VCA
sengs, see Fire and Smoke Detecon , Temperature Measurement , and Behavior
Analysis .
Note
The funcon is only supported by certain models.
9.1.14 Lens Parameters Adjustment
It is used to adjust the lens focus, zoom and iris.
Zoom
• Click , and the lens zooms in.
• Click , and the lens zooms out.
Focus
• Click , then the lens focuses far and the distant object gets clear.
• Click
, then the lens focuses near and the nearby object gets clear.
PTZ Speed
• Slide to adjust the speed of the pan/lt movement.
Iris
• When the image is too dark, click to enlarge the iris.
• When the image is too bright, click
to stop down the iris.
9.1.15 Conduct 3D
Posioning
3D posioning is to relocate the selected area to the image center.
Steps
1. Click to enable the funcon.
2. Select a target area in live image.
-
Le click on a point on live image: the point is relocated to the center of the live image. With
no zooming in or out
eect.
-
Hold and drag the mouse to a lower right posion to frame an area on the live: the framed
area is zoomed in and relocated to the center of the live image.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
51