HIKVISION DS-2TD6237-50H4L/W - Set Linear Scan; Set Limit

Reset paern scan path.
Delete the selected paern scan.
Note
If you need to delete all the paern scans, go to Conguraon → PTZ → Clear Cong , and
check Clear All Paerns, and click Save.
8.5 Set Linear Scan
The device can perform auto scan in seng area for re source detecon.
Steps
1. Go to
Conguraon → PTZ → Linear Scan .
2. Select the camera channel.
3. Zoom in and zoom out the camera to the appropriate zoom rao, and click Save Rao.
Note
Click Enable Saved Rao to set the camera to the saved zoom rao.
4. Check Enter Area Sengs.
5.
Set the le/right/up/down limits with the PTZ control panel, and click to conrm sengs.
6. Oponal: Click Clear to delete the saved scan area.
7. Click Save.
8. Click Call Linear Scan to start linear scan, and click Stop Linear Scan to stop linear scan.
Note
When seng the linear scan area, make sure the target area is both included in the opcal
channel and the thermal channel.
8.6 Set Limit
The device can only move within the limited range.
Steps
1. Go to Conguraon → PTZ → Limit .
2. Select Limit Type.
Manual Stops
It refers to the movement range limit when you control the device manually.
Scan Stops
It refers to the movement range limit when the device scans
automacally.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
41