HIKVISION DS-2TD6237-50H4L/W - Advanced Configuration

Note
The schedule for the channels can not overlap.
3. Click Save.
5.4 Advanced Conguraon
Go to Conguraon → VCA → Advanced Conguraon and congure the parameters.
Detecon Parameters
Detecon Sensivity
The higher the sensivity is, the easier the target will be detected.
Background Update Rate
if a detected target remains in the monitoring scene for a certain me, the system will count the
target as the background automacally. The greater the value is, the faster the target will be
counted as the background.
Minimum Target Size
The system will
lter out the object smaller than the minimum target size.
Displacement Constraint for Target Generaon
The higher the value is, the slower the target is generated, and the higher accuracy the analysis
will get.
Opcal-axis Movement
Check the funcon when the target moves in the direcon of camera's opcal -axis.
When the target is far from the device and the movement is not clear, enable this
funcon to
check the move direcon.
Single Alarm
The system only sends alarm once for one target triggering. Otherwise, the alarm will be
triggered
connuously unl the target disappears.
Scene Modes
The scene mode is set to be General by default. Select Distant View when you are far from the
targets. Select Leaves Interfered View when there are shaking targets in the scene, such as
leaves.
Restore Parameters
Restore Default
Click Restore to restore the parameters to the default.
Restart VCA
Click Restartto restart the VCA
funcon.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
25