HIKVISION DS-2TD6237-50H4L/W - Set IP Address Filter; Set SSH; Set HTTPS

13.14.3 Set IP Address Filter
IP address lter is a tool for access control. You can enable the IP address lter to allow or forbid
the visits from the certain IP addresses.
IP address refers to IPv4.
Steps
1. Go to
Conguraon → System → Security → IP Address Filter .
2.
Check Enable IP Address Filter.
3. Select the type of IP address lter.
Forbidden IP addresses in the list cannot access the device.
Allowed Only IP addresses in the list can access the device.
4. Edit the IP address lter list.
Add Add a new IP address to the list.
Modify Modify the selected IP address in the list.
Delete Delete the selected IP address in the list.
5. Click Save.
13.14.4 Set SSH
SSH is a protocol to ensure security of remote login. This seng is reserved for professional
maintenance personnel only.
Steps
1. Go to
Conguraon → System → Security → Security Service .
2. Check Enable SSH.
3. Click Save.
13.14.5 Set HTTPS
HTTPS is a network protocol that enables encrypted transmission and identy authencaon,
which improves the security of remote access.
Steps
1. Go to Conguraon → Network → Advanced Sengs → HTTPS .
2. Check Enable .
3. Click Delete to recreate and install cercate.
Create and install self-signed
cercate Refer to Create and Install Self-signed Cercate
Create cercate request and install
cercate
Refer to Install Authorized Cercate
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
91