HIKVISION DS-2TD6237-50H4L/W - Set Thermography Parameters

3.3.1 Set Thermography Parameters
Congure the parameters of temperature measurement.
Steps
1. Go to
Conguraon → Local , enable Display Temperature Info. .
Display Temperature Info.
Select Yes to display temperature
informaon on live view.
Display Rule Info. on Capture
Select Yes to display rule informaon on the capture.
Enable Rules to display the rules informaon on live view.
2. Click Save.
3. Go to
Conguraon → Temperature Measurement → Basic Sengs to congure parameters.
Enable Temperature Measurement
Check to enable temperature measurement funcon.
Enable Color-Temperature
Check to display Temperature-Color Ruler in live view.
Display Temperature Info. on Stream
Check to display temperature informaon on the stream.
Display Max./Min./Average Temperature
Check to display maximum/minimum/average temperature informaon on liveview when
the temperature measurement rule is line or area.
Posion of Thermometry Info
Select the posion of temperature informaon showed on the live view.
• Near Target: display the informaon beside the temperature measurement rule.
• Top
Le: display the informaon on the top le of screen.
Add Original Data on Capture
Check to add data on alarm triggered capture of thermal channel.
Add Original Data on Stream
Check to add original data on thermal view.
Data Refresh Interval
It means the refresh interval of temperature informaon.
Unit
Display temperature with Degree Celsius (°C)/Degree Fahrenheit (°F)/Degree Kelvin (K).
Temperature Range
Select the temperature measurement range.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
7