HIKVISION DS-2TD6237-50H4L/W - Set Initial Position; Set Scheduled Tasks

Note
Scan limit is only supported by the device that has scan funcon.
3. Click Set and set limits according to the prompt on the live image.
4.
Oponal: Click Clear to clear the limit sengs of the selected mode.
5. Click Save.
6. Check Enable Limit.
Note
If you need to cancal all the set patrol paths, go to Conguraon → PTZ → Clear Cong , select
Clear All PTZ Limited, and click Save.
Result
The device can only move within the set region aer saving the sengs.
8.7 Set
Inial Posion
Inial posion refers to the relave inial posion of the device azimuth. You can set the inial
posion
if you need to select one point in the scene as the base point.
Steps
1. Go to Conguraon → PTZ → Inial Posion .
2. Move the device to the needed posion by manually controlling the PTZ control buons.
3. Click Set to save the informaon of inial posion.
Call
The device moves to the set inial posion.
Clear Clear the set inial posion.
8.8 Set Scheduled Tasks
You can set the device to perform a certain task during a certain period.
Steps
1. Go to Conguraon → PTZ → Scheduled Tasks .
2. Check Enable Scheduled Task.
3. Select the a task type from the drop-down list and draw a
me bar on the schedule table.
4. Click the set me bar and set the acon ID and smart event or VCA type.
Note
Not all task types support the sengs of acon ID and smart event or VCA funcon. Please take
the actual product for reference.
5. Repeat step 3 and step 4 to set more than one scheduled tasks.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
42