HIKVISION DS-2TD6237-50H4L/W - Port Mapping; Set Auto Port Mapping; Set Manual Port Mapping

TCP-based full-duplex communicaon protocol port for plug-in free preview. Cercate
vericaon is required to ensure the secure access.
Note
• WebSocket Port and WebSockets Port are only supported by certain models.
• For device models that support that
funcon, go to Conguraon → Network → Advanced
Sengs → Network Service to enable it.
12.3 Port Mapping
By seng port mapping, you can access devices through the specied port.
Before You Start
When the ports in the device are the same as those of other devices in the network, refer to Port
to modify the device ports.
Steps
1. Go to
Conguraon → Network → Basic Sengs → NAT .
2. Select the port mapping mode.
Auto Port Mapping
Refer to Set Auto Port Mapping for detailed informaon.
Manual Port Mapping Refer to Set Manual Port Mapping for detailed informaon.
3. Click Save.
12.3.1 Set Auto Port Mapping
Steps
1. Check Enable UPnP™, and choose a friendly name for the camera, or you can use the default
name.
2. Select the port mapping mode to Auto.
3. Click Save.
Note
UPnP™ funcon on the router should be enabled at the same me.
12.3.2 Set Manual Port Mapping
Steps
1. Check Enable UPnP™, and choose a friendly name for the device, or you can use the default
name.
2. Select the port mapping mode to Manual, and set the external port to be the same as the
internal port.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
77