HIKVISION DS-2TD6237-50H4L/W - Set Qos

4. Click Save.
Create and Install Self-signed Cercate
Steps
1. Check Create Self-signed
Cercate.
2. Click Create.
3. Follow the prompt to enter Country/Region, Hostname/IP, Validity and other parameters.
4.
Click OK.
Result
The device will install the self-signed
cercate by default.
Install Authorized
Cercate
If the demand for external access security is high, you can create and install authorized cercate
via HTTPS protocol to ensure the data transmission security.
Steps
1. Select Create cercate request rst and connue the installaon.
2. Click Create.
3. Follow the prompt to input Country/Region, Hostname/IP, Validity and other parameters.
4. Click Download to download the
cercate request and submit it to the trusted authority for
signature.
5. Import
cercate to the device.
-
Select Signed
cercate is available, start the installaon directly. Click Browse and Install
to import the
cercate to the device.
-
Select Create the
cercate request rst and connue the installaon. Click Browse and
Install to import the
cercate to the device.
6. Click Save.
13.14.6 Set QoS
QoS (Quality of Service) can help improve the network delay and network congeson by seng
the priority of data sending.
Note
QoS needs support from network device such as router and switch.
Steps
1. Go to Conguraon → Network → Advanced Conguraon → QoS .
2. Set Video/Audio DSCP, Alarm DSCP and Management DSCP.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
92