HIKVISION DS-2TD6237-50H4L/W - Record Manually

Alarm
When alarm input is enabled and trigger recording is selected as linkage method, the video is
recorded aer receiving alarm signal from external alarm input device.
Moon | Alarm
Video is recorded when moon is detected or alarm signal is received from the external
alarm input device.
Moon & Alarm
Video is recorded only when
moon is detected and alarm signal is received from the
external alarm input device.
Event
The video is recorded when congured event is detected.
5. Set schedule for the selected record type. Refer to Set Arming Schedule for the seng
operaon.
6. Click Advanced to set the advanced sengs.
Overwrite
Enable Overwrite to overwrite the video records when the storage space is full. Otherwise
the camera cannot record new videos.
Pre-record
The me period you set to record before the scheduled me.
Post-record
The me period you set to stop recording aer the scheduled me.
Stream Type
Select the stream type for recording.
Note
When you select the stream type with higher bitrate, the actual me of the pre-record and
post-record may be less than the set value.
7. Click Save.
11.2.2 Record Manually
Steps
1. Go to Conguraon → Local .
2. Set the Record File Size and saving path to for recorded
les.
3. Click Save.
4. Click to start recording. Click to stop recording.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
72