HIKVISION DS-2TD6237-50H4L/W - Set the Presets

4.4 Set the Presets
Please set the presets according to steps below to improve the accuracy of re detecon.
Steps
1. If the presets located in
dierent areas, you can set 6 presets in two areas as the example
showed below.
Figure 4-2 Set the Presets for re detecon
2. Divide the scan area into three parts and set a preset every 120°. The black numbers are
presets, and the red numbers are scan areas.
3. Set the presets according to the sequence of patrol path: 1->2->3->1->4->5->6->4.
Note
• When set the presets, you should adjust the zoom
rao to view the image of both opcal
channel and thermal channel clearly.
• The recommended zoom rao of opcal channel and patrol speed shows in the table below.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
15