HIKVISION DS-2TD6237-50H4L/W - Set ISUP; Set Open Network Video Interface; Set Alarm Server

12.9 Set ISUP
When the device is registered on ISUP plaorm (formerly called Ehome), you can visit and manage
the device, transmit data, and forward alarm informaon over public network.
Steps
1. Go to
Conguraon → Network → Advanced Sengs → Plaorm Access .
2. Select ISUP as the
plaorm access mode.
3. Select Enable.
4. Select a protocol version and input related parameters.
5. Click Save.
Register status turns to Online when the
funcon is correctly set.
12.10 Set Open Network Video Interface
If you need to access the device through Open Network Video Interface protocol, you can
congure the user sengs to enhance the network security.
Steps
1. Go to Conguraon → Network → Advanced Sengs → Integraon Protocol .
2. Check Enable Open Network Video Interface.
3. Click Add to
congure the Open Network Video Interface user.
Delete
Delete the selected Open Network Video Interface user.
Modify Modify the selected Open Network Video Interface user.
4. Click Save.
5.
Oponal: Repeat the steps above to add more Open Network Video Interface users.
12.11 Set Alarm Server
The device can send alarms to desnaon IP address or host name through HTTP, HTTPS, or ISUP
protocol. The desnaon IP address or host name should support HTTP, HTTP, or ISUP data
transmission.
Steps
1. Go to
Conguraon → Network → Advanced Sengs → Alarm Server .
2. Enter Desnaon IP or Host Name, URL, and Port.
3. Select Protocol.
Note
HTTP, HTTPS, and ISUP are selectable. It is recommended to use HTTPS, as it encrypts the data
transmission during communicaon.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
83