HIKVISION DS-2TD6237-50H4L/W - Set Rules

Note
If you want to show the name on the image, check Display Scene Name.
4. Check Track to enable the target tracking
funcon for the scene.
5.
Oponal: Check Limited Tracking and set the auto tracking range.
The camera channel tracks a target only within the set auto tracking range.
1) Control the PTZ
buons to a desired scene and click Set Up Limit to save the posion as the
scene's upper boundary.
2) Repeat to set the le, right and lower boundaries of the scene.
6. Set other tracking parameters.
Tracking
Duraon
Set the duraon of tracking. If the value is selected as 0, the tracking duraon will not be
limited.
Zooming
Rao
It is the zoomed-in level when the camera channel is tracking a target.
Go to Conguraon → VCA → Zooming Rao , select a scene from the drop-down list, and
control the zoom in/out buons to get a desired zooming level, and save the sengs.
Post-tracking
Set the duraon of automac tracking of the target aer it stops.
Go to Conguraon → VCA → Advanced Conguraon , and set parameter.
7. Click Save.
5.3.2 Set Rules
The device can detect whether there is any target breaking the VCA rules. The opcal camera will
track the target or the device will alarm when the VCA rule is triggered.
Steps
1. Go to Conguraon → VCA → Scene Conguraon → Scene x → Rule .
2. Click
to add a new rule.
3. Enter the rule name, and click the drop down menu to select Rule Type.
Note
Each scene can be congured with dierent rule types. Up to 8 rules can be set for one scene.
Line Crossing
If any target move across the seng line, the alarm will be triggered. You can set the crossing
direcon.
Intrusion
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
22