HIKVISION DS-2TD6237-50H4L/W - Set Device Position; Set Manual Compass

8.12 Set Device Posion
Before You Start
Go to Conguraon → PTZ → Basic Sengs → PTZ OSD to enable PT Status display.
Steps
1. Go to the
seng page: Conguraon → PTZ → Posion Sengs .
2. Select a PT Mode.
Manual Use a direcon indicang device to determine the North at the device locaon,
and set the North for the device. For details, see Set Manual Compass .
Auto For the device that has built-in e-compass, the compass can automacally tell the
north direcon for the device. For details, see Set Auto Compass .
3. Check Installaon Angle Calibraon to perform angle calibraon one me when the device
installaon is nished.
It is used for situaons where the device is not installed horizontally, to increase the re source
detecon accuracy.
4. Set Vandal-proof alarm.
Aer enabling the funcon, the device triggers alarms once its posion changes because of
shock or vandalism.
Sensivity
The higher the value is, the easier the alarm will be triggered.
Upload Vandal-proof Alarm
The device uploads the alarm informaon when the alarm is triggered.
5. Get the device locaon informaon in advance, and input the longitude and latude of the
device manually.
6. Click Save.
What to do next
If you lost
direcon when operang the device, you can click Point to North to call the north
posion that is saved in the device.
8.12.1 Set Manual Compass
Use a direcon indicang device to determine the North at the device locaon, and set the North
for the device.
Before You Start
Use a
direcon indicang device to determine the north at the device locaon.
Steps
1. Select the PT Mode as Manual.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
45