HIKVISION DS-2TD6237-50H4L/W - Set Fire Detection Parameters

Table 4-1 Table of opcal channel zoom rao and patrol speed
16.7-1000
（focus
distance）
12.5-775
（focus
distance）
15.6-500
（focus
distance）
6.7-330（focus
distance）
10-320
（focus
distance）
6-240（focus
distance）
the le column is opcal rao, the right columns are speed level.
15
km
15 4 20 4 / / / / / / / /
10
km
10 5 15 4 12 4 / / / / / /
5 km 7 6 10 5 8 5 20 4 13 4 / /
3 to 5
km
5 6 7 6 6 6 13 4 9 5 15 4
4.5 Set Fire Detecon Parameters
To avoid the potenal re damage, you should congure the re detecon funcon for certain
areas. The detail conguraon steps show as below.
Before You Start
• The
re detecon funcon can locate the re source area quickly together with patrol or linear
scan. Please refer to Set Patrol Scan for conguring patrol. Please refer to Set the Presets for
presets seng.
• Please refer to Set Device Posion for locang the re source posion.
• Go to Conguraon → Local , set the re point parameters.
Locate Highest Temperature Point
Click and save to show the
posion of the highest temperature on the interface.
Frame Fire Point
Click and save to frame the detected re source.
Steps
1. Go to
Conguraon → Event → Smart Event , select Fire Detecon.
2. Check Enable Fire and Smoke Detecon.
3. Refer to Detecon Mode and Applicaon Scene for seng the re detecon mode.
4. Check Display Fire Source Frame on Stream to display a red frame around the
re source on
stream when re occurs.
5.
Seng the parameters of re detecon.
Detecon Mode
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
16