HIKVISION DS-2TD6237-50H4L/W - Configure the Behavior Analysis; Set Detection Scenes and Tracking

Enable it to display rules informaon on live view.
Display Rules Info. on Capture
Select Yes to display rules informaon on the capture.
2. Go to Conguraon → VCA .
3. Select the camera channel.
4. Go to Basic
Sengs to congure VCA parameters for the channel.
Display VCA Info. on Stream
Select to display target info and rule on stream, the informaon will be added to the video
stream, and the overlay will be displayed if you get live view or play back by the VS Player.
Display Target Info. on Alarm Picture
Select to display the target
informaon on the alarm picture.
Display Rule Info. on Alarm Picture
Select to display the rule informaon on the alarm picture.
Snapshot Sengs
Select to upload the picture to the surveillance center when the VCA alarm occurs. You can
also set the quality of the picture.
5. Click Save.
5.3
Congure the Behavior Analysis
This secon is the detailed instrucon of conguring the behavior analysis rules.
Steps
1. Go to Conguraon → VCA , and select a camera channel to start conguraon.
2. Refer to Set Detecon Scenes and Tracking for detecon scene and tracking sengs.
3. Refer to Set Rules to set the scene rules.
4. Refer to Set the Scene Auto-Switch for
seng scene patrol.
5. Go to Conguraon → VCA → Camera 02 → Basic Sengs , enableIntelligent Analysis.
6. Click Save.
5.3.1 Set
Detecon Scenes and Tracking
Mulple detecon scenes are supported for both channels. You can create scenes and set the
tracking parameters for
beer target monitoring performance.
Steps
1. Go to Conguraon → VCA , and select a camera channel.
2. Click Scene Conguraon and New Scene to create one or more scenes.
3. Select a numbered scene from the
navigaon bar on the le and enter a Scene Name.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
21