HIKVISION DS-2TD6237-50H4L/W - Mirror; Video Standard; Digital Zoom; Local Video Output

OFF
Disable this funcon.
Normal
Set the DDE level to control the details of the image. The higher the level is, the more details
shows, but the higher the noise is.
10.4.21 Mirror
When the live view image is the reverse of the actual scene, this
funcon helps to display the
image normally.
Select the mirror mode as needed.
Note
The video recording will be shortly interrupted when the funcon is enabled.
10.4.22 Video Standard
Video standard is an ability of a video card or video display device that denes the amount of
colors that are shown and the
resoluon. The two most common video standard used are NTSC
and PAL. In NTSC, 30 frames are transmied each second. Each frame is made up of 525 individual
scan lines. In PAL, 25 frames are
transmied each second. Each frame is made up of 625 individual
scan lines. Select video signal standard according to the video system in your country/region.
10.4.23 Digital Zoom
You can zoom in the image. The larger the zoom size is, the more blurred the image is.
10.4.24 Local Video Output
If the device is equipped with video output interfaces, such as BNC, CVBS, HDMI, and SDI, you can
preview the live image directly by
connecng the device to a monitor screen.
Select the output mode as ON/OFF to control the output.
10.5 OSD
You can customize OSD (On-screen Display)
informaon such as device name, me/date, font,
color, and text overlay displayed on video stream.
Go to OSD
seng page: Conguraon → Image → OSD Sengs .
Select a channel.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
66