HIKVISION DS-K1T341A Series User Manual

The specic person can open the door by inpung the super password.
Note
• The duress code and the super code should be dierent.
• The duress code and the super password should be dierent from the
authencaon
password.
• The length of duress code and the super password is according the device, usually it should
contains 4 to 8 digits.
5. Click OK.
6. Oponal: Click Cop
y to , and then select the door to copy the parameters in the page to the
selected doors.
Note
The door's status duraon
sengs will be copied to the selected door(s) as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card reader parameters.
St
eps
1. Click Access Control → Advanced Funcon → Device Parameter .
2. In the device list on the le, click
to expand the door, select a card reader and you can edit
the c
ard reader's parameters on the right.
3. Edit the card reader basic parameters in the Basic Informaon page.
Note
• The displayed parameters may vary for dierent access control devices. There are part of
par
ameters listed as follows. Refer to the user manual of the device for more details.
• Some of the following parameters are not listed in the Basic Informaon page, click Advanced
to edit the parameters.
Basic Informaon
Name
E
dit the card reader name as desired.
Minimum Card Swiping Interval
If the interval between card swiping of the same card is less than the set value, the card
swiping is invalid. You can set it as 0 to 255.
Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts reach the set value.
Card Reader Type/Card Reader Descripon
DS-K1T341A Series Face
Recognion Terminal User Manual
123

HIKVISION DS-K1T341A Series Specifications

General

Brand	HIKVISION
Model	DS-K1T341A Series
Category	Touch terminals
Language	English