Hioki BT3554-51 - Visual Prompt from the Instrument

98
Visual Prompt From the Instrument
6.2 Visual Prompt From the Instrument
You can perform measurements by following the visual prompt from
the instrument alone. GENNECT Cross will not operate in sync with
the instrument.
To compare measured values with the threshold values, preset the
comparator function.
See “4 Comparator Function (Evaluation Based on Threshold
Values)” (p. 67).
1
Switch over the display to
the prole number selection
mode.
2
Choose a prole number to
be used in the measurement
recording prompt.
3
Conrm your entry.
The automatic hold function and
automatic memory function will
automatically be enabled.
HIOKI BT3554F961-00HIOKI BT3554F961-00