101
Visual Prompt and Voice Prompt
6.3 Visual Prompt and Voice Prompt
You can perform measurements by following the voice prompt from
GENNECT Cross (version 1.8 or later required) that communicates
with the instrument.
To compare measured values with the threshold values, preset the
comparator function.
See “4 Comparator Function (Evaluation Based on Threshold
Values)” (p. 67).
1
Hold down the key for at least 1 s (When the
wireless communications function is disabled).
The wireless communications function will be enabled.
Connecting the Z3210 Wireless Adapter (option) is required.
2
Run GENNECT Cross on your mobile device and register
the instrument to pair with.
3
Select the battery function on GENNECT Cross.
4
Use GENNECT Cross to start the measurement recording
prompt.
The blinking [VOICE] segment will appear on the display.
HIOKI BT3554F961-00HIOKI BT3554F961-00
To Next Page
Loading...
