114
Automatic Power Saving Function (APS)
8.2 Automatic Power Saving Function
(APS)
Enabling the automatic power saving function can reduce power
consumption of the instrument. The instrument will automatically be
turned o if inactivity continues for about 10 minutes in one of the
following states:
• When the resistance readout exhibits the [−−−−] segments
• Freezes measured data (Measurement suspension state)
• In mode other than measurement mode (Any of setup modes or
data readout mode)
• After completion of communications.
The [APS] segment will start blinking one minute before shuto.
The following conditions will disable this function.
• While communicating with a computer or a mobile device
• While the measurement recording prompt is operating
HIOKI BT3554F961-00HIOKI BT3554F961-00
To Next Page
Loading...
