Diagnostics
[ Diagnostics > Status Configuration > Security Status ]
241
RM GUI GRS
Release
8.0
09/2019
Possible values:
marked
(default setting)
Monitoring is active.
If at least one of the following conditions applies, then in the
Security status
frame, the value
changes to
error
:
– The
SNMPv1
function is enabled.
– The
SNMPv2
function is enabled.
– The encryption for SNMPv3 is disabled.
You enable the encryption in the
Device Security > User Management
dialog, in the
SNMP
encryption type
column.
unmarked
Monitoring is inactive.
You specify the settings for the SNMP agent in the
Device Security > Management Access > Server
dialog,
SNMP
tab.
Access to system monitor with serial interface possible
Activates/deactivates the monitoring of the system monitor.
When the system monitor is activated, the user has the possibility to change to the system monitor
via a serial connection.
Possible values:
marked
Monitoring is active.
If you activate the system monitor, then in the
Security status
frame, the value changes to
error
.
unmarked
(default setting)
Monitoring is inactive.
You activate/deactivate the system monitor in the
Diagnostics > System > Selftest
dialog.
Saving the configuration profile on the external memory possible
Activates/deactivates the monitoring of the configuration profile in the external memory.
Possible values:
marked
Monitoring is active.
If you activate the saving of the configuration profile in the external memory, then in the
Security
status
frame, the value changes to
error
.
unmarked
(default setting)
Monitoring is inactive.
You activate/deactivate the saving of the configuration profile in the external memory in the
Basic
Settings > External Memory
dialog.
Load unencrypted config from external memory
Activates/deactivates the monitoring of loading unencrypted configuration profiles from the external
memory.
To Next Page
Loading...
