303
Test Run
(6) The temperature detections by the thermistors are invalid though the protection devices are valid during the test run.
(7) To nish the test run, press “ ” (run/stop) again or pass over
the set test run time. When changing the test run time, press
“
∧
” or “
∨
” to select “Running Time”. Then, set the test run
time (30 to 600 minutes) by pressing “
＜
” or “
＞
”.
Indoor Unit No. Which Abnormality Occurs
Refrigerant Cycle No. of Indoor Unit Which
Abnormality Occurs
Unit Model Code
Total No. of Indoor Unit in Same Refrigerant
Cycle as one that Abnormality Occurs
Alarm Code No.
● The RUN indicator on the remote control switch ashes
when some abnormalities such as protection devices
activated occur during the test run as well as the RUN
indicator (red) on the indoor unit ashed (0.5 second
ON/0.5 second OFF). Additionally, the alarm code, the
unit model code and connected number of indoor units
will be displayed on the LCD as shown in the gure
below. If the RUN indicator on HYXE-J01H ashes.
It may be a failure in the transmission between the
indoor unit and the remote control switch (loosening of
connector, disconnecting wiring or breaking wire, etc.).
Consult to authorized service engineers if abnormality
can not be recovered.
To Next Page
Loading...
Need help?
General
