To Next Page

To Previous Page

Outdoor Unit Installation

3.2 Factory-Supplied Accessories

Check to ensure that the following accessories are packed with the outdoor unit.

Table 3.1 Factory-Supplied Accessories unit: in.(mm)

72 96 120 144 168 192

Accessory

Pipe Pouch

Screw (Spare)

Installation Manual

×3

Electrical

Accessory Pouch

Fastener Pouch

×1

× 1

NOTE:

If any of these accessories are not packed with the unit, please contact your contractor.

3.3 Installation

(1) Install the outdoor unit in a dry and well ventilated environment.

(2) Install the outdoor unit in the shade or where it will not be exposed to direct sunshine or direct radiation from high

temperature heat source.

(3) Install the outdoor unit where the sound or the discharge air from the outdoor unit does not a󰀨ect neighbors or

surrounding ventilation.

The operating sound at the rear or right/left sides is 3 to 6dB(A) higher than the nominal value at the front side.

(4) Install the outdoor unit in a space with limited access to general public.

(5) Check to ensure that the foundation is at, level and su󰀩ciently strong.

(6) Do not install the outdoor unit where dust or other contamination could block the outdoor heat exchanger.

(7) When installing the outdoor unit in snow-covered areas, mount the eld-supplied hoods on the top of the outdoor unit

and the inlet side of the heat exchanger.

(8) In heating or defrosting operation, drain water is discharged. Provide adequate drainage around the foundation. If

installing the unit on a roof or a veranda, avoid draining in or over walkways to prevent water dripping on people or the

formation of ice in winter. In case of installing in such a place, provide additional drainage around the foundation.

(9) Do not install the outdoor unit in a space where a seasonal wind directly blows to the outdoor heat exchanger or a wind

from a building space directly blows to the outdoor fan.

NOTE:

(1) Do not install the outdoor unit where there is a high level of oil mist, ammable gases, salty air or harmful gases such as

sulphur and an acid or alkaline environment.

(2) Do not install the outdoor unit where the electromagnetic wave directly radiates to the electrical control box.

(3) Install the outdoor unit as far as possible, being at least 9.8 ft. (3m) from the electromagnetic wave radiator.

Hisense AVWT-192FFFH User Manual

Questions and Answers: