The following procedure varies depending on BIOS version.
For BIOS version 2.02a1, perform the following procedure.
For BIOS version 2.12a13, skip to
Confirming parameters of FC
mezzanine card when BIOS version is 2.12a13 on page 7-8.
7. The BIOS utility is displayed. Enter < number > and then press Enter
key.
< number > : 1 or 3 the first port number of the failed card
Note: When two Emulex FC mezzanine cards are installed in mezzanine
slot #2 and #4, the first port of the mezzanine card in slot #4 is indicated
in number 3 line.
8. Confirm and record Port Name and Node name.
9. Confirm and record the BIOS setting, which is Enabled or Disabled.
10. Enter 1, and then press Enter key to confirm registered boot device.
Configuring Emulex mezzanine card
7-5
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
