Starting the own router is performed by turning on the power switch or the power
breaker on each router chassis. See Subsection 6.4.2 for the locations and in/out
positions of these power switches and breaker switches. Pay attention to the
following Notes.
*
Note: When you turn off and turn on the same router power successively,
pause at least 2 seconds before you turn on the power.
*
Note: For a router with duplexed (redundant) power supply, turn on the
two power/breaker switches one after the other within 10 seconds.
*
Note: When turning on a breaker switch, make sure you move the lever
switch fully until it stops.
To Next Page
Loading...
Need help?
General
