5. SPECIFICATION
5-14
(3/3)
Top
menu
Setting item Default value Note
Power After AC Power On Auto Specifies the action when the power to the
equipment is turned on.
Stay Off: When the power is turned on, the
system goes into the soft power off
mode.
Power On: When the power is turned on, the
OS is started automatically.
Auto: If the OS was running the last time the
power was turned off, the OS starts as in
the case of Power On. If the OS was not
running the last time the power was
turned off, the system goes into the soft
power off mode as in the case of Stay
Off.
For information about the precautions to be
observed when the power from the backup
battery is not available, see “PRECAUTION
10. PRECAUTIONS ABOUT THE BIOS
SETTINGS”.
FAN failure detection Enabled Specifies whether the until will detect a fan
failure when the power is turned on.
Do not change this setting.
FAN speed control Auto Set the rotational speed of the fan.
Auto: The fan speed changes automatically
according to the CPU temperature.
Full: Fan speed is always maximum.
Power saving mode Disabled Specifies whether to launch the CPU in the
power saving mode.
Do not change this setting.
Boot Boot Priority Order 1. USB FDD
2. SATA CD/DVD
3. USB CD
4. DRIVE1
5. DRIVE2
6. PCI SCSI
! 7.USB HDD
8.Internal Shell
Configures the priority order of the devices
from which an OS is booted.
Do not change this setting.
Exit Exit Saving Changes
-
Saves the changes you made in the setup into
the SPI-ROM and reboots the system.
Exit Discarding Changes Discards the changes you made in the setup and
reboots the system with the configuration you
saved in the SPI-ROM last time.
Load Setup Defaults Loads the BIOS default settings.
Default values are loaded but not saved in the
SPI-ROM. If you want to save the default
settings in the SPI-ROM, use “Exit Saving
Changes”.
To Next Page
Loading...
Need help?
General
