Hitachi HF-W2000 User Manual

6. CHECKUP AND MAINTENANCE
6-7
6.3.3 Installing and removing the cover of the equipment
CAUTION
When you install the cover of the equipment, do not put your fingers inside
the cover. If you do, your fingers may get caught and injured.
Before starting to work, see “6.3.2 Before installing or removing components”.
(1) Removing the cover of the equipment
[1] Remove the three screws on the rear of the equipment.
[2] Slide the cover to the rear of the equipment.
[3] Slightly pull the sides of the cover apart from the body of the equipment and then lift the
cover up and away.
Figure 6-2 Removing the Cover of the Equipment
(2) Installing the cover of the equipment
When installing the cover of the equipment, reverse the procedure described in “(1)
Removing the cover of the equipment.” Then according to Figure 6-2 install the center
screw first.
[1]
[2]
[3]
[1]
[1]
(*) When installing the cover of the equipment,
install this screw first.

Hitachi HF-W2000 Specifications

General

Brand	Hitachi
Model	HF-W2000
Category	Desktop
Language	English