10. SOFTWARE RAID1
10-34
10.6.5 Consistency check function
The consistency check function checks consistency of data of all areas of the HDDs in drive bay 1
and drive bay 2. Use this function for periodic inspection to enhance computer availability.
Use the consistency check function as follows.
1. Display the Soft RAID Utility menu window.
<Notice>
• The consistency check function is enabled only while both drives are in the
ONLINE state. In other states, this function is disabled and cannot be selected on
the menu window.
• The consistency check takes about 90 minutes. However, the checking time
increases when many mismatches of data are found and many sectors must be
corrected.
To Next Page
Loading...
