7. RESTORING THE FACTORY-SHIPPED CONDITION USING A RECOVERY DVD
7-3
7.3 Restoring the System Drive Back to the Factory-Shipped Condition
7.3.1 Procedure for restoring the system drive back to the factory-shipped condition
Follow the procedure below to restore the system drive of an HF-W2000 Model 48/45 back
to the factory-shipped condition using a recovery DVD.
1. Turn on the power to the computer, and insert a recovery DVD “HITACHI HJ-204*-****
Product Recovery DVD” to the DVD drive. If the number of recovery DVDs is multiple,
insert a first disc (For example, if the number of recovery DVDs two insert the disc
number : 1/2).
(Note) The underlined part is the model number of the equipment you purchased, and
therefore the part indicated as * is different depending on the model. In the
following description of the procedure, replace the “HJ-204*-****
” with the actual
model number of the equipment you purchased.
2. When you boot from the recovery DVD, the confirmation message is displayed.
(Note) If you cannot boot from the recovery DVD, turn off the computer, and then turn it
back on.
(Note) Only in the case B model, the following screen is displayed. Select [Product
Recovery Utility] and click [Start] button.
If you click Shut Down, the following message box is displayed. Click OK.
The recovery DVD is automatically ejected, and then the computer is
automatically shut down.
If you want to go back to the confirmation message window, click Cancel
To Next Page
Loading...
Need help?
General
