5. Expand Drives, and then check the drive that has the ISO
.
6. Click Connect.
7. When prompted to enter your credentials, enter your SVP password and click OK.
8. Perform the appropriate step:
■ If you have WinZip installed on the VM, extract the ISO locally, and then go to
step 9 to run the setup application.
■ Otherwise, click the mapped drive in the left pane and double-click the Setup
application in the workspace to the right of the pane (see the following gures),
and then go to step 9.
Note: Using WinZip is the pr
eferred method. The alternative method
performs the installation over the network and can take signicantly
longer to complete.
Installing the SVP software
Chapter 7: Installing the SVP software on a VMware ESXi host
Service Processor Technical Reference 160
To Next Page
Loading...
