8. T
o verify that the new LAN IP settings are correct for your environment, exit to a
command prompt (DOS) window and ping controller 1 and controller 2 using the
new IP addresses. Do not proceed until this step is successful.
9. In the Storage Device List window, click the SVP IP address setting in the top-right
of the window.
10. Change the SVP IP addr
ess to match the new bridge IP address setting, and then
click Apply.
11. In the Stor
age Device List window, click Edit.
12. Select the Connect Information check bo
x, change the IP addresses for CTL1 and
CTL2, and then click Apply.
Chapter 15: Editing the Storage Device List
Service Processor Technical Reference 230
To Next Page
Loading...
