Hitachi UX2 - Page 235

Chapter 9. Environment Setup
9-7
Chapter 9.
(3) Change character orientation (Change mode) supplement
● The character orientation at reciprocative printing signal input is different depending on the "Change
Character orientation" and "Change mode" set values. See the table below.
Reciprocative printing signal and character orientation
(When "Change Character orientation" = "Reverse direction printing")
Change mode
Character orientation
Reciprocative printing signal
OFF
ON
OFF＝forward
０：ＡＢＣ（→）
Order of printing
Order of printing
１：ＡＢＣ（←）
２： （←）
Order of printing
Order of printing
３： （→）
OFF＝reverse
０：ＡＢＣ（→）
Order of printing
Order of printing
１：ＡＢＣ（←）
２： （←）
Order of printing
Order of printing
３： （→）
Reciprocative printing signal and Character orientation
(When "Change Character Orientation" = "Normal and inverted")
Change mode
Character orientation
Reciprocative printing signal
OFF
ON
OFF＝normal
０：ＡＢＣ（→）
Order of printing
Order of printing
２： （←）
１：ＡＢＣ（←）
Order of printing
Order of printing
３： （→）
OFF＝inverted
０：ＡＢＣ（→）
Order of printing
Order of printing
２： （←）
１：ＡＢＣ（←）
Order of printing
Order of printing
３： （→）