7-12
To ensure safe operation, be sure to conduct periodic inspec-
tion of the machine. In addition, the parts listed below, if de-
fective, may pose serious safety/fire hazards. It is very difficult
to gauge the extent of deterioration, fatigue, or weakening of
the parts listed below simply by visual inspection alone. For
this reason, replace these parts at the intervals shown in the
table below. However, if any of these parts are found to be
defective, replace before starting operation, regardless of the
interval.
Also, when replacing hoses, check the clamps for deformation,
cracks, or other deterioration, and replace as necessary.
Be sure to perform periodic inspection of all hoses, as shown
below, and replace or retighten any defective parts found, as
necessary.
Consult your authorized dealer for correct replacement.
Periodic Replacement Parts Replacement Intervals
Engine
Fuel hose (Fuel tank to filter) Every 2 years
Fuel hose (Fuel tank to injection pump) Every 2 years
Oil filter hose (Engine to oil filter) Every 2 years
Heater hose (Heater to engine) Every 2 years
Brakes
Breake valve seals (Rubber parts) Every 1 years
Wet type brake (D-ring for piston) Every 4 years
Breke hose Every 2 years
Stop light switch Every 2 years
Center joint seals (Rubber parts) Every 2 years
Brake hose Every 1 years
Steering Machanism
Steering hose Every 2 years
Steering cylinder seals (Rubber parts) Every 4 years
Steering valve seals (Rubber parts) Every 2 years
Hydraulic
System
Base Machine
Pump suction hose Every 2 years
Pump delivery hose Every 2 years
Front
Attachment
Lift arm cylinder line hose Every 2 years
Bucket cylinder line hose Every 2 years
Pilot hose Every 2 years
Cab Seat belt Every 3 years
NOTE: Be sure to replace seals, such as O-rings and gaskets,
when replacing hoses.
To Next Page
Loading...
