7-58
M4GB-07-064
M4GB-07-066
ZW220, ZW250
4
1. Remove cartridge filter (2) from fuel filter (1) with a filter
wrench. Be sure to retain fuel with a container to ensure
safety and to protect the ground against contamination
2. Coat fuel to the gasket surface on new cartridge filter ele
-
ment (2).
3. Install cartridge filter element (2) to water separator (1)
by lightly turning the element by hand until the seal sur
-
face makes contact with the gasket.
4. Tighten the cartridge filter element more approx. 2/3
turns using the filter wrench. Take care not to overly
tighten the cartridge filter element. Deformation of car
-
tridge filter (2) may result.
5. Bleed air from the fuel system
After replacing the filter element, bleed air from the fuel
system.
[Refer to the descriptions for “Bleed air from the fuel sys
-
tem” in item (3).]
M4GF-07-012
ZW180
To Next Page
Loading...
