7-59
M4GB-07-065
ZW310
1. Close vent valve (5) by turning it clockwise.
2. Open plug (4) and drain valve (3). Drain fuel from the fil
-
ter.
3. Turn to remove the filer element (1) with separator con
-
tainer (2).
4. Remove the separator container (2) from the filter ele
-
ment (1). Clean the element. Replace the element as
needed.
5. Replace the O-ring with a new one.
6. Securely tighten the filter element to the filter head by
hand.
7. Install the filter element in the reverse order of removal
procedures.
8. After replacing the water separator filter, bleed air mixed
in the fuel system.
[Refer to the descriptions for “Bleed air from the fuel sys
-
tem” in item
3
.]
To Next Page
Loading...
