Hitachi ZW310 - Fuel System; Check Fuel Level


7-53
M4GB-01-030
M4GB-01-151




 


Use high quality DIESEL FUEL only (JIS K-2204) (ASTM 2-D).
Kerosene must NOT be used.
 





1. Park the machine on a level surface.
2. Lower the bucket to the ground.
3. Engage the park brake.
 


4. Run the engine at slow idle speed without load for 5 min
-
utes.
5. Stop the engine. Remove the key from the key switch.
6. Pull the front control lever lock to the LOCK position.
 


7. Check fuel gauge (1) of the monitor panel. Add fuel if
necessary.
 

8. To avoid condensation, fill the tank at the end of each
day’s operation. Take care not to spill fuel on the machine
or ground.
Fuel tank capacity
ZW180: 230 liters
ZW220: 285 liters
ZW250: 340 liters
ZW310: 382 liters
9. Install and lock fill cap (2) immediately after fueling.
      


1