N4680 2D Decoded Scan Engine User Guide 83
Single Scan Data Format Change
You can also switch between data formats for a single scan. The next bar code is
scanned using an alternate data format, then reverts to the format you have
selected above (either Primary, 1, 2, or 3).
For example, you may have set your device to the data format you saved as Data
Format 3. You can switch to Data Format 1 for a single trigger pull by scanning the
Single Scan-Data Format 1 bar code below. The next bar code that is scanned uses
Data Format 1, then reverts back to Data Format 3.
Single Scan-Primary
Data Format
Single Scan-Data Format 1
Single Scan-Data Format 2
Single Scan-Data Format 3
To Next Page
Loading...
