N4680 2D Decoded Scan Engine User Guide 43
Character Deactivation Mode
If you have sent a character from the host to trigger the scan engine to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the follow-
ing On bar code to use character deactivation, then use Deactivation Character
(following) to select the character you will send from the host to terminate scan-
ning. Default = Off.
Deactivation Character
This sets the character used to terminate scanning when using Character Deacti-
vation Mode. On the ASCII Conversion Chart (Code Page 1252), page 216, find the
hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the Programming Chart inside the back
cover of this manual to read the alphanumeric combination that represents that
ASCII character. Scan Save to finish. Default = 14 [DC4].
Poor Quality Codes
Poor Quality 1D Codes
This setting improves the scanner’s ability to read damaged or badly printed linear
bar codes. When Poor Quality 1D Reading On is scanned, poor quality linear bar
code reading is improved, but the scanner’s snappiness is decreased, making it
less aggressive when reading good quality bar codes. This setting does not affect
2D bar code reading. Default = Poor Quality 1D Reading Off.
Poor Quality 1D Reading On
To Next Page
Loading...
