10 N4680 2D Decoded Scan Engine User Guide
CTS/RTS Emulation
ACK/NAK Mode
Remote MasterMind™ for USB
When using a USB interface, you may wish to configure your scanner to communi-
cate with Remote MasterMind Scanner Management Software (ReM). Scan the
ReM On bar code to communicate with ReM. To disable this capability, scan ReM
Off.
Keyboard Country Layout
If your interface is USB Keyboard or Keyboard Wedge, your keyboard layout default
is a US keyboard. To change this layout, refer to the chart below for your keyboard
country. Scan the appropriate bar code below to change the layout.
By default, national character replacements are used for the following characters:
#$@[\]^‘{|}~ See ISO 2022/ISO 646 Character Replacements on page A-222 to
view the character replacements for each country.
To Next Page
Loading...
