N4680 2D Decoded Scan Engine User Guide 41
Note: To turn off Mobile Phone Read Mode, scan a Manual or Serial Trigger Mode bar code
(see page 32).
Character Activation Mode
You may use a character sent from the host to trigger the scan engine to begin
scanning. When the activation character is received, the scan engine continues
scanning until either the Character Activation Timeout (page 3-42), the deactiva-
tion character is received (see Deactivation Character on page 43), or a bar code is
transmitted. Scan the following On bar code to use character activation, then use
Activation Character (following) to select the character you will send from the host
to start scanning. Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the ASCII Conversion Chart (Code Page 1252), page 216, find the hex
value that represents the character you want to use to trigger scanning. Scan the
Hand Held Scanning - Mobile
Phone
Streaming Presentation -
Mobile Phone
To Next Page
Loading...
