Honeywell N4680 - GS1 Databar Expanded Message Length; GS1 Databar Expanded Redundancy

N4680 2D Decoded Scan Engine User Guide 129
GS1 DataBar Expanded Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 86) for additional information. Minimum and Maximum lengths
= 4-74. Minimum Default = 4, Maximum Default = 74.
GS1 DataBar Expanded Redundancy
If you are encountering errors when reading GS1 DataBar Expanded bar codes, you
may want to adjust the redundancy count. Redundancy adjusts the number of
times a bar code is decoded before transmission, which may reduce the number of
errors. Note that the higher the redundancy count, the longer it will take to decode
the bar code. To adjust the redundancy, scan the GS1 DataBar Expanded Redun-
dancy bar code below, then scan a redundancy count between 0 and 10 on the
Programming Chart. Then scan the Save bar code. Default = 0.
Minimum Message Length
Maximum Message Length
GS1 DataBar Expanded
Redundancy