N4680 2D Decoded Scan Engine User Guide 123
EAN/JAN-8 On/Off
EAN/JAN-8 Check Digit
This selection allows you to specify whether the check digit should be transmitted
at the end of the scanned data or not. Default = On.
EAN/JAN-8 Redundancy
If you are encountering errors when reading EAN/JAN-8 bar codes, you may want
to adjust the redundancy count. Redundancy adjusts the number of times a bar
code is decoded before transmission, which may reduce the number of errors. Note
that the higher the redundancy count, the longer it will take to decode the bar code.
To adjust the redundancy, scan the EAN/JAN-8 Redundancy bar code below, then
scan a redundancy count between 0 and 10 on the Programming Chart. Then scan
the Save bar code. Default = 0.
To Next Page
Loading...
