N4680 2D Decoded Scan Engine User Guide 181
9
SERIAL PROGRAMMING
COMMANDS
The serial programming commands can be used in place of the programming bar
codes. Both the serial commands and the programming bar codes will program the
scan engine. For complete descriptions and examples of each serial programming
command, refer to the corresponding programming bar code in this manual.
The device must be set to an RS232 interface (see page 7). The following com-
mands can be sent via a PC COM port using terminal emulation software.
Conventions
The following conventions are used for menu and query command descriptions:
Menu Command Syntax
Menu commands have the following syntax (spaces have been used for clarity
only):
parameter A label representing the actual value you should send as part of a command.
[option] An optional part of a command.
{Data} Alternatives in a command.
bold Names of menus, menu commands, buttons, dialog boxes, and windows that
appear on the screen.
To Next Page
Loading...
Need help?
General