N4680 2D Decoded Scan Engine User Guide 37
Idle Illumination - Presentation Mode
Note: This setting is not supported by N360X Series.
Scan one of the bar codes below to set the lED illumination for the scanner when it
is in an idle state in Presentation Mode. Default = High.
Note: If you use one of the lower Idle Illumination settings, and there is not enough ambient
light, the scanner may have difficulty detecting when a bar code is presented to it. If
the scanner has difficulty “waking up” to read bar codes, you may need to set the Idle
Illumination to a brighter setting.
Presentation LED Behavior after Decode
When a scan engine is in presentation mode, the LEDs dim 30 seconds after a bar
code is decoded. If you wish to dim the LEDs immediately after a bar code is
decoded, scan the LEDs Off bar code, below. Default = LEDs On.
To Next Page
Loading...
