Honeywell N4680 - Code 39

N4680 2D Decoded Scan Engine User Guide 69
Example: Send a number of characters
Send the first 10 characters from the bar code above, followed by a carriage return.
Command string: F2100D
The data is output as: 1234567890
Example: Split characters into 2 lines
Send the first 10 characters from the bar code above, followed by a carriage return,
followed by the rest of the characters.
Command string: F2100DF10D
The data is output as:
1234567890
ABCDEFGHIJ
<CR>
F3—Send all characters up to a particular character
Include in the output message all characters from the input message, starting with
the character at the current cursor position and continuing to, but not including,
the search character “ss,” followed by an insert character. The cursor is moved for-
ward to the “ss” character. Syntax = F3ssxx where ss stands for the search charac-
ter’s hex value for its ASCII code, and xx stands for the insert character’s hex value
for its ASCII code.
Refer to the ASCII Conversion Chart (Code Page 1252), beginning on page 216 for
decimal, hex and character codes.
Example: Send all characters up to a particular character
F2 “Send a number of characters” command
10 Number of characters to send
0D Hex value for a CR
F2 “Send a number of characters” command
10 Number of characters to send for the first line
0D Hex value for a CR
F1 “Send all characters” command
0D Hex value for a CR