N4680 2D Decoded Scan Engine User Guide 33
Trigger Toggle
Trigger Toggle mode lets you quickly hit the trigger two or three times to put the
scanner into either imaging mode or centering mode, then toggle back to scan-
ning. So, like a double-click with a mouse, you can control what the next scanner’s
action will be. For example, you could double-press the trigger to go into imaging
mode, then the next trigger press takes the image. The scanner then reverts to
scanning mode. Use the following codes to configure what action you would like
the scanner to take when in Trigger Toggle mode. Default = Off.
Trigger Number
This sets the number of trigger preses required to activate the Trigger Toggle Mode.
Default = 3 Quick Triggers.
Trigger Toggle - Image Capture
Trigger Toggle - Centering
To Next Page
Loading...
