Honeywell N4680 - B3-Insert Symbology Name; B4-Insert Bar Code Length

72 N4680 2D Decoded Scan Engine User Guide
The data is output as:
1234567890**ABCDEFGHIJ
<CR>
B3—Insert symbology name
Insert the name of the bar code’s symbology in the output message, without mov-
ing the cursor. Only symbologies with a Honeywell ID are included (see Symbology
Charts on page 213). Refer to the ASCII Conversion Chart (Code Page 1252),
beginning on page 216 for decimal, hex and character codes.
B4—Insert bar code length
Insert the bar code’s length in the output message, without moving the cursor. The
length is expressed as a numeric string and does not include leading zeroes.
B3 and B4 Example: Insert the symbology name and length
Send the symbology name and length before the bar code data from the bar code
above. Break up these insertions with spaces. End with a carriage return.
Command string: B3F42001B4F42001F10D
The data is output as:
Code128 20 1234567890ABCDEFGHIJ
<CR>
2A Hex value for an asterisk (*)
2A Hex value for an asterisk (*)
F1 “Send all characters” command
0D Hex value for a CR
B3 “Insert symbology name” command
F4 “Insert a character multiple times” command
20 Hex value for a space
01 Number of times the space character is sent
B4 “Insert bar code length” command
F4 “Insert a character multiple times” command
20 Hex value for a space
01 Number of times the space character is sent
F1 “Send all characters” command
0D Hex value for a CR