110 N4680 2D Decoded Scan Engine User Guide
adjust the redundancy, scan the UPC-A Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the Programming Chart. Then scan the
Save bar code. Default = 0.
UPC-A Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-A data.
Default = Off for both 2 Digit and 5 Digit Addenda.
UPC-A Addenda Required
When Required is scanned, the scanner will only read UPC-A bar codes that have
addenda. You must then turn on a 2 or 5 digit addenda listed on page 110. Default
= Not Required.
To Next Page
Loading...
